Removing pattern from an artifact

Discussion in 'General Discussion' started by Innascual Inch, Feb 3, 2021.

Thread Status:
Not open for further replies.
  1. Innascual Inch

    Innascual Inch Avatar

    Messages:
    311
    Likes Received:
    694
    Trophy Points:
    43
    Has anyone removed a pattern from an artifact?

    I am trying to remove a Darkstarr chainmail leggings eternal pattern from bandit leggings. I cannot use the reshape pattern remover recipe on any crafting table.

    Perhaps removing patterns from artifacts is not possible (yet...)?
     
    Innascual Inch, Feb 3, 2021
    #1
  2. Barugon

    Barugon Avatar

    Messages:
    15,715
    Likes Received:
    24,335
    Trophy Points:
    153
    Gender:
    Male
    Pattern removers should work. If it doesn't then maybe post a bug report?
     
    Barugon, Feb 3, 2021
    #2
  3. Anpu

    Anpu Avatar

    Messages:
    7,944
    Likes Received:
    9,015
    Trophy Points:
    153
    Location:
    Hemut
    Salvaging it will give the pattern back but destroy the item. Pattern removers will give the pattern back but leave the item intact.
     
    Anpu, Feb 3, 2021
    #3
  4. Cora Cuz'avich

    Cora Cuz'avich Avatar

    Messages:
    4,654
    Likes Received:
    7,616
    Trophy Points:
    153
    Location:
    Veritas Sanctuary
    You could also try applying another pattern, if you have one. That should give you the eternal pattern back. The dirty/rusty leggings drop like crazy in low level cultist scenes, shoudln't take too many to get a pattern off one.
     
    Cora Cuz'avich, Feb 3, 2021
    #4
    Barugon likes this.
Thread Status:
Not open for further replies.