Dismiss Notice
This Section is READ ONLY - All Posts Are Archived

[Known] Free Standing Short and Long Heraldry Banner don't get fully black

Discussion in 'Items & Inventory' started by Mal Hari, Oct 4, 2018.

Thread Status:
Not open for further replies.
  1. Mal Hari

    Mal Hari Avatar

    Messages:
    266
    Likes Received:
    742
    Trophy Points:
    28
    Gender:
    Male
    Location:
    The Jade Valley
    Free Standing Short and Long Heraldry Banner don't get fully black
    Used Pure Black Dye on these banners and they don't get fully black in ether zone 1 or 2.
    Also i believe zone 2 is bleeding over onto zone 1.

    Using Short as example.
    1. Banner on left both zones Pure black zone 1 is darker due to zone 2 bleedover. also note you don't see any black on the edges.
    2. Banner on right zone 1 pure black zone 2 magical glowing green dye. Zone 1 has a green tint from zone 2 Bleedover.

    zone 1 should go full black just like my Cloak shown in pic.

    [​IMG]
     
    Rentier likes this.
  2. Serafina

    Serafina Portalarian Emeritus

    Messages:
    1,302
    Likes Received:
    1,658
    Trophy Points:
    113
    Submitted 62315
     
Thread Status:
Not open for further replies.