Dismiss Notice
This Section is READ ONLY - All Posts Are Archived

[Info needed] 2 Storey palm tree stuck under ground on Villiage lot

Discussion in 'Release 42 Bug Forum' started by Tripp Swindle, Jun 15, 2017.

Thread Status:
Not open for further replies.
  1. Tripp Swindle

    Tripp Swindle Avatar

    Messages:
    14
    Likes Received:
    18
    Trophy Points:
    15
    Gender:
    Male
    Location:
    Victoria, Australia
    1. Title: 2 Storey palm tree stuck under ground on Villiage lot
    2. Reproduction Rate: %100 allows to rotate underground.
    3. Blocker? No
    4. Details: Placing a 2 Storey palm on top of a small stone paver the tree lay down sideways when right on the edge of the paver. When rotated it went underground and allowed placement. End result is the two items are now connected and the Tree cannot be selected to remove it. Villiage size lot in POT Isle of Xee.
    5. Steps to Reproduce: Did not attempt to successfully place.
    6. User Specs: Win 10 64bit
     
  2. Lexie

    Lexie Bear Queen Emeritus

    Messages:
    842
    Likes Received:
    2,902
    Trophy Points:
    93
    I'm a little confused by this. the tree cannot be selected to remove it but you did not attempt to successfully place?
    Did you capture screenshots by change?
    @Tripp Swindle
     
  3. Tripp Swindle

    Tripp Swindle Avatar

    Messages:
    14
    Likes Received:
    18
    Trophy Points:
    15
    Gender:
    Male
    Location:
    Victoria, Australia
    Sorry for the confusion. The tree did successfully place. I could just see the base of the tree poking out of the paver (base of the trunk). I was only able to select the paver however. I ended up removing the home as I could not separate the two objects.
     
    Lexie likes this.
Thread Status:
Not open for further replies.