Dismiss Notice
This Section is READ ONLY - All Posts Are Archived

[Info needed] Can only place Candles and Candelabras in a few spots in my house

Discussion in 'Release 40 Bug Forum' started by Zeetocht, Mar 30, 2017.

Thread Status:
Not open for further replies.
  1. Zeetocht

    Zeetocht Avatar

    Messages:
    53
    Likes Received:
    96
    Trophy Points:
    8
    Gender:
    Male
    Location:
    San Diego, CA, USA
    Since R40 I'm unable to place candles or candelabras in most of my house except the basement- I get the message "You cannot place this item here because it is a light source and would be too near other light sources". I tried removing nearby light sources and then couldn't replace those resulting in the same message.
     
  2. Widsith [MGT]

    Widsith [MGT] Avatar

    Messages:
    714
    Likes Received:
    646
    Trophy Points:
    93
    Light source radius seems to be going through walls, among other things.
     
  3. Serafina

    Serafina Portalarian Emeritus

    Messages:
    1,302
    Likes Received:
    1,658
    Trophy Points:
    113
    @Zeetocht Can you tell me what type of house you have? And could you give me a couple screenshots of where you're trying to place the candles?
     
  4. Mariothegreat

    Mariothegreat Avatar

    Messages:
    14
    Likes Received:
    50
    Trophy Points:
    3
    Same thing happens with all light sources in row houses, can not even replace existing light sources!
     
  5. Barugon

    Barugon Avatar

    Messages:
    15,717
    Likes Received:
    24,337
    Trophy Points:
    153
    Gender:
    Male
    The problem is that there is logic that will not allow you to place a light source if it's too close to another light source, even if that other light source is on another floor. This is in addition to the light limit that you already have on your lot and it's very confusing because there's absolutely no feedback other than you can't place a light source.

    You can work around this by removing nearby light sources that have a large light radius (like candelabras, wall torches, etc), placing your new light and then replacing the old light.
     
  6. Justyn

    Justyn Bug Hunter Bug Moderator

    Messages:
    1,216
    Likes Received:
    701
    Trophy Points:
    113
    I haven't checked in R40, but in the last couple of releases the candelabras were blocking the placement of deco on the floors above. We had to pull them all up, do the deco and then go back and put them down again.
     
  7. Zeetocht

    Zeetocht Avatar

    Messages:
    53
    Likes Received:
    96
    Trophy Points:
    8
    Gender:
    Male
    Location:
    San Diego, CA, USA
Thread Status:
Not open for further replies.