Norgard Knightly Order Plate Armor vs. Cloaks

When you wear a suit of Norgard Knightly Order Plate Armor, and then try to wear a cloak it doesn't nicely drape over the armor. It floats above the armor and looks horrid.

It Sits forward and up from the chest armor which clips into the helmet above it and also leaves a huge floating gap on the front of your armor above your chest.

Cloak mesh location needs to be adjusted so that it sits further down and back on top of the chest armor.

Common Cloak, worn cloak, and front clasp cloak used.

I was going to put this in with Bugs section of forums, but realized it's not really a bug; just a meshing/modeling oversight.

Edit: Also the same applies to the Plate Armor of Courage model as well. Same floating.
The Front clasp Cloak looks exceptionally horrid, because it's like 3 sizes too large for these armors. It's like wearing a 3xl large shirt on a medium frame.

 

Modeling issues are bugs as well.

Although it may be that this is as good as it gets for the moment, as making it so it drapes over an invisible something on the back is how they keep it from clipping through the front of the model and it looking like a diaper.

Still if there are specific outfits that it's cloaks aren't working with at all, bug it.

 

I've been complaining about this since forever. Check out the shroud if you want to see something really bad.

 

Just wear the really cool leaf backpack!

 

Hasn't been fixed in 4 years so good luck with it.